Planning Window

You can plan a new route with the commands Planning a new route or Planning a round trip.

• A new route with the name “New Route” is created and saved in the active route table.
• The info of this new route opens in a panel docked on the left
• In the map window the en:32_mapwindow:30_edit_22222_edit_mode with append points is activated.

So you can immediately start to select or click the route points one by one on the map.

With the command Planning a round trip you can plan a new round trip. The Graphhopper routing engine is required for this. You can choose from different profiles, motorbike curved, car, bicycle etc.

• Set the desired, approximate length of the route and
• optionally a direction in which the round trip should start from the start
• Then click on the desired starting point on the map, which is also the end point.
• Now click on Generate to calculate the route:

Now you can vary the parameters length and direction, click Generate each time until the result fits.

Planning a route